![]()
So you actually have to make 3 edits in the script, not just the one on line 3 and 5. – When editing the script make sure line two which says “built in audio output” is the same output device as the one you put on line 5. #Hotkey for audioswitcher install#The two lines start with echo and eval and it says so right at the end of the install of homebrew. If you don’t do these, you’ll get a brew command not found error, so watch out for these. #Hotkey for audioswitcher code#– After installing homebrew, there’s a lot going on in terminal and it’ll take a while to complete, but there’s two lines of code you need to run manually at the end, which it tells you you need to run, but you might miss. #Hotkey for audioswitcher mac#You can always do it the free, native way on your Mac by following these instructions. #Hotkey for audioswitcher software#It’s not necessary to use BTT, as any mapping software would work.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |